In this article we will show you How to disassemble a kitchen siphon to stop water loss
under wash basins or kitchen or bathroom sinks. In addition to the difficulty of drying constantly, water loss can damage furniture.
During quarantine, on weekends or holidays, there are some issues that you can take care of that are very easy to solve and that can have serious consequences if not resolved in a timely manner.
then Loss of water can lead to discomfortbecause the ground is constantly wet. But the worst can happen when the furniture is made of wood because it can constantly worsening. It can even affect items that are kept under the counter.
What is a toilet siphon and how does it work?
The flush trap is the pipe that sits under the sink in the kitchen or bathroom. It’s an inverted U-shaped tube, one side longer than the other. Its function is direct fluid into the cloaca. The same system is used in the toilet to prevent the unpleasant smell of sewage from returning to the interior of the house.
Loose seals can cause water to leak, and clogged seals can prevent the drain from leaking. The seals are made of rubber or PVC, so they tend to come off. This is the first thing to check if you notice any water loss.
If tightening the nuts is insufficient, the siphon must be replaced. To do this, we need to determine what type of siphon to buy, that is, the difference is whether it is one or two sink systems.
The best material is PVC, but you can choose the material that best suits your budget. Then we will show you, step by step, how to dismantle a kitchen siphon in order to replace it.
In an emergency, you can get advice from a. request Plumber or professional plumber.
How to disassemble a kitchen siphon
Remove the old siphon
The steps to disassemble a kitchen or bathroom siphon are very simple. To remove the siphon from the kitchen or bathroom, simply open the lower counter and loosen the nut under the sink, it can be a bracket.
Then the nut or clamp that connects the siphon to the sewer. Must be Completely remove the entire systemTry to keep it straight as there is water in it. Hence, it needs to be transferred directly to a rack to drain and set aside.
Install the new siphon
Now we need to install the new system which we need to fully assemble before we put it under the sink.
The pipes are placed in the rubber elbows as they can only penetrate up to 3 cm, otherwise they can clog the duct. Once everything is assembled we will present it to you.
They usually coincide with the previous one, in case the pipes are longer, they need to be measured and cut correctly. Since it’s made of PVC, it’s very easy to cut to size with a small saw or knife. It is important to present it before the cuts because everything has to fit together perfectly.
The siphon with single and double washbasins has a cleaning plug. Unscrew by hand before assembly and use silicone sealant. The silicone layer should not exceed one millimeter. Then screw it in by hand, never use a tool.
As soon as the system is fully assembled, it should be placed under the sink and adapted to the sink drain and drain using the appropriate brackets.
If you have any problems, do not hesitate to consult a specialist. Here you will find Plumber’s base price.
Test the new siphon
We just have to check that everything is working properly. To do this, we need to let the water run for 10 minutes. It can be tested immediately as the silicone does not require any drying time.
To avoid losing water in the grout, you can wipe it off with a paper towel.
As you can see, dismantling a siphon for a kitchen or bathroom is very easy, even if it is a sink or a sink with one or two sinks.
Frequent cleaning is the key to keeping things running smoothly. To do this, it is enough to unscrew the bottom and remove all accumulated waste and grease.
Another very common problem in households is a leaking faucet or leaking water. We’ll tell you in the next article How to change the head of a conventional and single-leaf coil.